Troubleshooting a S244T Hayward Basket Strainer Sand filter
The hayward basket strainer S244T sand filter uses fine sand to keep the pool water clean. The most common problems that can occur with this filter can be remedied by the owner in most cases, following the troubleshooting steps. Instructions, first, check the skimmer basket for debris if there is low water flow. Through the unit, debris clogging the basket will hamper the flow of water.
Check the filter basket of the debris pump. Basket strainers for pumps of the clogged pump will reduce the flow of water. Inspect the intake line for leaks. Leaks in the suction pipe will affect the flow of water. Leaks can be found by following the bubbles that emanate from the intake line to the pool. Check the backwashing filter for debris or obstructions. Change the backwash filter if it is clogged or dirty. Check the pool for algae if the filters are often clogged. If the algae are present, super chlorinate the pool to eliminate it.
Inspect the surface of the filter sand for any agglomeration or crust. Stir up to 1 inch of sand that is crusted or matted. Check the Vari-Flo valve if the water is not clearing. Make sure that the valve is placed in the “Filter” position. Increase the flow velocity if the pool water is not clearing. A flow rate that is too low will prevent the filter from effectively flushing the pool water. Check the pH, alkaline and chlorine levels of the pool water if the water is not clearing. Adjust each of these levels, if necessary. And the hayward basket strainers troubleshooting were done.